8. LED Display
LED display indicates the printer status.
1.Green LED on
-The printer waits for the data from Host (PC) in normal mode.
2.Orange LED on
-It means paper gap sensing error. It becomes on when the printer fails to detect the paper or paper jam occurred. When fails to detect the paper correctly use
3.Red LED on
-The printer has stopped by pressing FEED button. It restarts printing when pressed again.
4.Green LED blinking
1)TPH (Thermal Printing Head) overheated or ;
2)The printers is waiting for the button input to run
5.Orange LED blinking
-No paper. Make sure the paper is loaded correctly.
6.Red LED blinking
1)The printer cover is open or ;
2)Auto cutter has error such as paper jam in case of auto cutter
9. Pause / Restart
Press FEED button to pause at the middle of labels printing.
1.Pause
-Press FEED once. Printer stops after
2.Restart
-Press FEED once again. It restarts printing in a queue.
10. Gap Sensor Auto-Calibration
Gap sensor
1.Make sure that paper roll has been installed properly.
2.Turn on the power while holding down FEED button with cover open. Then the Green LED blinks.
On
3.Close the cover and guide message is printed automatically. Then a printer waits for input with red LED on.
4.Press FEED button once to initialize gap sensor and set it back to the factory setting. LED changes to Orange.
5.Press FEED button twice to run
LED changes first to Orange and second to Green. It feeds
Make sure to press a button one by one while checking LED changes.
6.Saved sensing value remains valid at power off unless otherwise above gap sensor initialization is executed again.
ٻ | ڌڍٻ | ٻ | ڌڎ |