Samsung 6050 manual Operator Panel Button Usage, Function Description

Operator Panel Button Usage

The operator button is located in the operator panel. It can be used to accomplish the following functions:

Function	Description
On line and	Briefly press the button. Each time you press the button, the printer goes
Off line	to on-line or off-line status. The READY light goes on and off according to
	the line status.
	To print data, the printer should have on-line status.
Self test	To perform a printer self-test:
	While the printer is on-line (READY light on), press and hold down the
	button until all three lights are blinking (approximately four seconds),
	then release the button. A one-page printer status sheet will be printed.
Printer reset	If the READY light is blinking slowly and the printer does not print any
	image, or if you want to cancel the print job and remove the unprinted
	data from the printer, reset the printer.
	Press the button to turn the printer off-line. With the READY light off,
	press and hold down the button until all lights are blinking
	(approximately four seconds), then release the button.
OPC Cleaning	If you are getting streaks or spots on your prints, the OPC drum on your
	printer may need to be cleaned.
	While the printer is on-line (READY light on), press and hold down the
	button until all three lights remain lit (not blinking; approximately seven
	seconds) and the printer begins to cycle up (the printer begins to feed
	paper), then release the button. One sheet will be printed.

1-6 Introduction