Screen shows strange colors or just black and white

The screen shows strange colors or just black and white.

Is the screen displaying only one color as if looking at the screen through a cellophane paper?

Have the screen colors become strange after running a program or due to a crash between applications?

Check the signal cable connection.

Make sure the video card is fully inserted in it's slot.

Reboot the computer.

The screen suddenly has become unbalanced.

Has the video card been set properly?

Have you changed the video card or the driver?

Have you adjusted the resolution or frequency to the monitor?

Set the video card by referring to the video card manual.

Adjust screen image position and size using the OSD.

Adjust the resolution and frequency at the video card.

(Refer to the Preset Display Modes).

The screen can be unbalanced due to the cycle of the video card signals. Readjust Position by referring to the OSD.

The screen is out of focus or OSD cannot be adjusted.

LED is blinking but no images on the screen.

There are only 16 colors shown on the screen. The screen colors have changed after changing the video card.

Have you adjusted the resolution or frequency on the monitor?

Is the frequency properly adjusted when checking the Display Timing on the menu?

Have the Windows colors been set properly?

Has the video card been set properly?

Adjust the resolution and frequency of the video card.

(Refer to the Preset Display Modes).

Adjust the frequency properly by referring to the video card manual and the Preset Display Modes.

(The maximum frequency per resolution may differ from product to product.)

For Windows ME/XP/2000: Set the colors properly at the Control Panel, Display, Settings.

Set the video card by referring to the video card manual.

There is a message		Have you installed the monitor
that reads		driver?
"Unrecognized


monitor, Plug & Play		See the video card manual to
(VESA DDC) monitor		see if the Plug & Play (VESA
found".		DDC) function can be
		supported.

Install the monitor driver according to the Driver Installation Instructions.

Check the following items if there is trouble with the monitor.

1.Check if the power cord and the cable are properly connected to the computer.

2.Check if the computer beeps more than 3 times when booting.

(If it does, request an after-service for the main board of the computer.)

3.If you installed a new video card or if you assembled the PC, check if the installed the adapter (video) driver and the monitor driver.

4.Check if the scanning ratio of the video screen is set at 75Hz or 85Hz. (Do not exceed 60Hz when using the maximum resolution.)

5.If you have problems in installing the adapter (video) driver, boot the computer in Safe Mode, remove the Display Adapter at the "Control Panel, System, Device Administrator" and then reboot the computer to reinstall the adapter (video) driver.

Note: If problems repeatedly occur, contact an authorized service center.