Front View of the CD-R/RW Drive

	5	6
1	2	3 4

1 Headphone Connector

The audio output connector enables you to plug stereo headphones into the drive. It requires a 3.6mm stereo mini-jack.

2 Volume Control Dial

This control dial adjusts the volume for your headphones. You can only use the headphone jack and volume control when you have installed the required software utilities. For example, the Microsoft Windows Media player can be used.

3 Reading/Writing LED

When you play a disc.(ORANGE)

4 Emergency Hole

If the disc tray does not open when you press the Open/Close

button, insert a small, metal rod(an unwound paper clip for example) into this hole to eject the disc.

☛This function should only be perfomed when the computer is powered OFF.

5 Disc Tray

The Disc Tray opens and closes automatically when you press the Open/Close button.

◆When you place a disc in the tray, make sure that the label on the disc is facing upwards. If you are not loading or unloading a disc, the disc tray should remain closed.

6 Open/Close-Button

Press open/close key.

Rear View of the CD-R/RW Drive

English

1 Digital Audio

You can connect a sound card or MPEG card which support Digital Audio to your drive using this two-pin connector.

2 Audio Output Connector

You can connect a sound card to your drive using this four-pin connector.

☛This function is not covered in detail in this guide. Refer to the documentation supplied with your sound card.

3 Device Configuration Jumper

Usually, this is a pre-set configuration as illustrated below:

CSM

S L A

☛Verify that the setting is as illustrated. If it is not, simply remove the jumper and place it in the correct position.

4 Host IDE Interface Connector

This input/output interface connector is used to connect the 40-pin flat cable from the IDE interface to the CD-R/RW drive.

5 Power Connector

The power connector is a four-conductor male plug.