Samsung B2230HD, B2330HD Before Requesting Service, Problems Related to Installation PC Mode

5-2 Before Requesting Service

Please check the following before requesting After-Sales service. If the problem continues, please contact your nearest Samsung Electronics Service Centre.

PROBLEMS RELATED TO INSTALLATION (PC MODE)

The monitor screen flickers.

Check if the signal cable between the computer and the monitor is securely connected and tightened.

(Refer to Connecting to a Computer)

PROBLEMS RELATED TO SCREEN
Screen is blank and power indicator is off.		Ensure that the power cord is firmly connected and the LCD monitor is on.
		(Refer to Connecting to a Computer)
<Check Signal Cable> message		Ensure that the signal cable is firmly connected to the PC or video sources.
		(Refer to Connecting to a Computer)
<Mode not supported> message is shown		Check the maximum resolution and the frequency of the video adapter.
		Compare these values with the data in the Standard Signal Mode Table.
Picture rolls vertically.		Check if the signal cable is securely connected.Connect it again securely.
		(Refer to Connecting to a Computer)
Image is not clear. Picture is blurred.		Run Frequency <Coarse > and < Fine> tuning.
		Turn on again after removing all accessories(video extension cable, etc.)
		Set resolution and frequency to the recommended ranges.
Picture image is unstable and vibrates.		Check if the resolution and frequency set for the computer video card falls
		in the range supported by the monitor. If not, reset them referring to the
Ghost images are shown in the picture.
		current <Information> under the monitor menu and Standard Signal Mode
		Table.
The image is too light or too dark		Adjust the Brightness and Contrast
		(Refer to the <Brightness>, <Contrast>)
		The display brightness can differ according to the mode set for <MagicAn-
		gle>.
		If <MagicBright> is set to <Dynamic Contrast>, the display brightness can
		differ according to the input signal.
Screen is blank and the power indicator light		The monitor is using its power management system
blinks every 0.5 or 1 seconds		Press a key on the keyboard
The screen is blank and is blinking.		If you see the TEST GOOD message on the screen when you press the [
		MENU] button, check the cable connection between the monitor and the
		computer to ensure that the connector is properly connected.
	PROBLEMS RELATED TO AUDIO
No sound		Ensure that the audio cable is firmly connected to both the audio-in port on
		your monitor and the audio-out port on your sound card.
		(Refer to Connecting to a Computer)
		Check the volume level.
The sound level is too low.		Check the volume level.
		If the volume is still too low after turning the control to its maximum, check
		the volume control on the computer sound card or software program.

5-2 Troubleshooting