Samsung 932BW manual Connecting Cables, Using the Stand, Folding the base

Page 17

Model

Connecting Cables

Connect the power cord for your monitor to the power port on the back of the monitor.

Plug the power cord for the monitor into a nearby outlet.

Use appropriate connection for your computer.

Using the D-sub (Analog) connector on the video card.

- Connect the signal cable to the 15-pin, D-sub port on the back of your monitor.

[RGB IN]

Using the DVI (Digital) connector on the video card.

- Connect the DVI Cable to the DVI IN Port on the back of your Monitor.

[DVI IN]

Connected to a Macintosh.

- Connect the monitor to the Macintosh computer using the D-sub connection cable.

Turn on your computer and monitor. If your monitor displays an image, installation is completed.

Using the Stand

Folding the base

Image 17
Contents SyncMaster 932BW Notation PowerPage Installation Page Others Cleaning and UsingPage Page Good Postures When Using the Monitor Page Product Information Image Retention Free Page Package Contents FeaturesCable Your MonitorOthers Sold separatelyNot available in MagicBright mode of Dynamic Contrast Rear Graphic cards DVI in port using the DVI cableFolding the base Connecting CablesUsing the Stand You can tilt the monitor upwards at an angle of 0 to18 Monitor Driver Installing the Monitor Driver AutomaticInstalling the Monitor Driver Manual Page Page Page Page Page Uninstalling the Natural Color Software Program Installing the Natural Color SoftwareNatural Color MagicTuneUninstall Direct Functions Control ButtonsOSD Locked & Unlock MagicBright Brightness OSD OSD FunctionColor Not available in MagicBright mode of Dynamic Contrast Image OSD Setup Information RTACheck List Refer to the Preset Timing ModesInstallation Instructions Feature is found only Self-Test Self-Test Feature CheckUseful Tips EnvironmentSpecifications EPA/ENERGY PowerSaverPreset Timing Modes Page Contact Samsung Worldwide Belgium Terms Authority For Better Display