Samsung 820TSn, 700TSn Maintenance and Cleaning, Symptoms and Recommended Actions, Check List

Page 88

Maintenance and Cleaning

1)Maintaining the LCD Display Case.

Clean with a soft cloth after disconnecting the power cord.

Do not use benzene, thinner or other flammable substances, or a wet cloth.

We recommend that a Samsung cleansing agent is used to prevent damage to the screen.

2)Maintaining the Flat Panel Display Screen. Clean with a soft cloth (cotton flannel) smoothly.

Never use acetone, benzene or thinner.

(They may cause flaws or deformation of the screen surface.)

The user will be required to pay costs and related expenses for repairing damages caused.

Symptoms and Recommended Actions

Note

A LCD Display recreates visual signals received from the computer. Therefore, if there is a problem with the computer or the video card, this can cause the LCD Display to become blank, have poor coloring, become noisy, and video mode not supported, etc. In this case, first check the source of the problem, and then contact a Service Center or your dealer.

1)Check if the power cord and the video cables are properly connected to the computer.

2)Check if the computer beeps more than 3 times when booting.

(If it does, request an a service for the main board of the computer.)

3)If you installed a new video card or if you assembled the PC, check if you installed the Adaptor(video).

4)Check if the scanning ratio of the video screen is set to between 50 Hz ~ 85 Hz. (Do not exceed 60Hz when using the maximum resolution.)

5)If you have problems in installing the Adaptor (video) driver, boot the computer in Safe Mode, remove the Display Adaptor in the "Control Panel, System, Device Administrator" and then reboot the computer to reinstall the Adaptor (video) driver.

Check List

Note

The following table lists possible problems and their solutions. Before calling for assistance, check the information in this section to see if you can remedy any problems for yourself. If you do need assistance, please call the phone number on the Information section or contact your dealer.

Problems related to the Installation (PC Mode)

Note

• Problems related to the LCD Display installation and their solutions are listed.

Problems

Solutions

The LCD Display screen flickers.

z Check if the signal cable between the computer and the LCD

Image 88
Contents Safety Instructions Using the SoftwareAdjusting the LCD Display TroubleshootingSafety Instructions PowerModel NotationalInstallation Do not drop the LCD Display when moving it Clean Others Do not cover the vents on the LCD Display cabinet Outlet and contact the Service Center If the batteries are swallowed, see a doctor immediately Power Installation Guide Power Installation Guide898 Package Contents Quick Setup GuideIntroduction Sub CableAdjust buttons Left-Right buttons/ Volume buttons Adaptor Jack Wall Mount KIT DVI CableLAN Cable Your LCD Display FrontPower button Power indicatorRemote Control Sensor PIPDVI / PC / Hdmi in RGB PC Video Connection Terminal RS232C OUT/IN RS232C Serial PortDVI / PC / Hdmi in Dvihdcp PC Video Connection Terminal Remote Control LAN LAN Connection Terminal USB USB Connection TerminalOn / OFF MagicInfoMDC MagicInfo buttonsMenu EnterAuto 15 CH/PDUAL/MTS Audio Type MTS/SModeFM Stereo Stereo REW820DXn Installation Vesa Bracket Wall Bracket Installation To mount the product on the wall bracket Wall Bracket Angle Adjustment Page 700DXn Installation Vesa Bracket Wall Bracket Installation To mount the product on the wall bracket Wall Bracket Angle Adjustment Page Installing the Stand KIT Installing the Semi StandConnecting the LCD Display ConnectionsUsing a Power cord with Earth Connecting a ComputerConnecting a VCR Connecting a DVD PlayerConnecting a Camcorder Connecting a DTV Set Top Box Connecting to an Audio SystemConnecting Hdmi Connecting to a Wired Remote ControlConnecting Using a DVI to Hdmi Cable Connecting a LAN Cable Connecting a USB deviceUsing the Software Installing the Monitor Driver AutomaticInstalling the Monitor Driver Manual Monitor DriverPage Page Page Page Page Introduction Main ScreenPort Selection Power Control Page Input Source Image Size PC, BNC, DVIImage Size TV, AV, S-Video, Component, DVIHDCP, HDMI, DTV Time PIP PIP SizePIP Source Settings Picture Settings Picture PC Settings Settings Image Lock AudioMaintenance Lamp Control Maintenance Scroll Maintenance Video Wall Troubleshooting Settings Value Display In Multiple Display Mode IRTouch Screen Control Panel General Control Panel menuModes Setting Enable Touch Enabledefault/disable touchscreen General setting of touchscreen Serial port SettingsAttachment Installment Specification Adjusting the LCD Display Input Available ModesSource List BNC DVI Video ComponentDirect button on the remote control is the Swap button Size Picture PC / BNC /DVI Mode Available ModesTransparency High Medium Low OpaqueDirect button on the remote control is the M/B button Off Cool Normal Warm Custom Available in PC, BNC mode onlyEntertain InternetDirect button on the remote control is the Auto button Red Green BlueOff CoarseSignal Balance Signal Control169 SharpnessOff Cool2 Cool1 Normal Warm1 Warm2 Film Mode Dynamic ContrastDigital NR Digital Noise Reduction Available Modes PIP on SoundYou can hear the sound even when sound value is set to Off Direct button on the remote control is the SRS buttonStandard MusicMain Sub Available Modes PIP on Setup Sleep TimerOn Timer Off TimerNormal Low Video WallOff Format FullFive adjustment levels 1, 2, 3, 4, Vertical Five adjustment levels 1, 2, 3, 4, Screen DividerSafety Screen Off IntervalImage Reset Color ResetOff 1024 X 1280 X 1360 x 1366 X Normal PivotID Setup Multi Control Available ModesID Input Direct Functions Available ModesMagicInfo Available Modes Select Magicinfo in the Source List menuPhoto Original Slide ShowRotation ClosePassword ConnectionFile Play OptionTroubleshooting Self-Test Feature CheckSelf-Test Feature Check Not Optimum ModeMaintenance and Cleaning Symptoms and Recommended ActionsProblems related to the Installation PC Mode Check ListProblems related to Audio Problems related to the ScreenScreen is blank and it is blinking Problems related to the Remote Control Remote control buttons do not respondProblems related to MagicInfo No sound Sound level is too lowPage General SpecificationsGeneral PowerSaver MagicInfo ClientPreset Timing Modes PowerSaverPreset Timing Modes SyncMaster 820TSn RAM State For Better Display InformationProduct Information Image Retention Free Power Off, Screen Saver, or Power Save Mode Apply the Screen Scroll function on Product Apply the Screen Erasing function on Product Contact Samsung Worldwide AppendixHonduras CIS Terms Sync Signal ResolutionDot Pitch Vertical FrequencyCorrect disposal of batteries in this product Europe only Multiple Display Control MDCAuthority