Using (a), you can rotate the screen within a range of 0 ~ 90 degrees. Using (b), you can use the screen lengthwise.
Press the top side of the stand and then push the button at the rear bottom of the stand.
You can adjust the stand height using this button.
When you are using a stand height as maximum, it will go down a little bit from spring elasticity.
If you rotate the screen without lifting it to its maximum height, the screen may be damaged because the edge of the screen would hit the floor.
Tilt angle
Using (c), you can adjust the height.
You can adjust the tilt within a range of 0 ~ 25 degrees.
Using (d), you can horizontally rotate it within a range of
Removing the base
1.Turn off your monitor and unplug its power cord.
2.Lay the LCD monitor
3.Remove four screws(A) and then remove the Stand from the LCD monitor.
Attaching a Base
This monitor accepts a 100 mm x 100 mm