Samsung 2232BWPLUS, 2032GWPLUS quick start Connecting Cables, Using the Stand, Folding the base

Page 6

Model

Connecting Cables

Connect the power cord for your monitor to the power port on the back of the monitor.

Plug the power cord for the monitor into a nearby outlet.

Use a connection appropriate to the computer you are using.

Using the D-sub (Analog) connector on the video card.

- Connect the signal cable to the 15-pin, D-sub port on the back of your monitor.

[RGB IN]

Using the DVI (Digital) connector on the video card.

- Connect the DVI Cable to the DVI IN port on the back of your Monitor.

[DVI IN]

Connected to a Macintosh.

- Connect the monitor to the Macintosh computer using the D-sub connection cable.

Turn on your computer and monitor. If your monitor displays an image, installation is completed.

Using the Stand

Folding the base

Page 5 Page 7
Image 6
Page 5 Page 7
Contents LCD Monitor Features Package ContentsOthers Your MonitorCable Sold separatelyNot available in MagicBright mode of Dynamic Contrast Rear Graphic cards DVI in port using the DVI cableFor using a locking device, contact where you purchase it Locking device has to be purchased separatelyConnecting Cables Using the StandFolding the base You can tilt the monitor upwards at an angle of 0 to18 Refer to the Preset Timing Modes Check ListInstallation Instructions Feature is found only Contact the video card manufacturer for details Self-Test Feature CheckSelf-Test Refer to the Windows / Computer ManualEnvironment Useful Tips
Top Page Image Contents