refer to the (Standard Signal Mode Table)
The color is displayed in 16 bit (16 colors). The color has been changed after changing the graphics card.
Did you install the device driver for the product?
Is the graphics card configured correctly?
Windows ME/XP/2000 : Set the color again by selecting Control Panel
→Display → Settings.
Configure the color again in accordance with the new graphics card driver.
When I connect the monitor, the 'Unknown monitor, Plug&Play (VESA DDC) monitor found' message is displayed.
Did you install the device driver for the product?
Check if all the Plug&Play (VESA DDC) functions are supported refer- ring to the User Manual of the graphics card.
Install the device driver referring to the descriptions about the driver installation.
Install the device driver referring to the descriptions about the driver installation.
When I look at the exterior edges of the product, small alien substances appear on it.
Since this product is designed so that the color has a soft appearance by coating it with a transparent material over the black edges, such things may be seen. This is not a defect of the product.
A "beep, beep" sound is heard when booting the computer.
If the beep sound is generated 3 or more times when booting up the computer, please request service for the computer.
5-3. FAQ
FAQ!
How can I change the frequency of the video signal?
How can I change the resolution?
How can I use the power saving function?
Please try the following!
You have to change the frequency of the graphics card.
(For more information, refer to the User Manual of the computer or the graphics card.)
Windows XP : Change the resolution by selecting Control Panel → Ap- pearance and Themes → Display → Settings.
Windows ME/2000 : Change the resolution by selecting Control Panel
→Display → Settings.
(For more information, refer to the User Manual of the computer or the graphics card.)
Windows XP : Configure it by selecting Control Panel → Appearance and Themes → Display → Screen Saver Setting or configure it in the BIOS Setup of the computer.
Windows ME/2000 : Configure it by selecting Control Panel → Display
→Screen Saver Setting or Configure it in the BIOS Setup of the com- puter.
For more information, refer to the Windows user manual for the com- puter.