Polaroid TDA-03211C manual Programming Your Remote Control

Programming Your Remote Control

PROGRAMMING YOUR REMOTE CONTROL

Your remote lets you control four devices with one easy-to-use, compact unit. After installing batteries, you can program the remote to control your Universal TV, VCR or DVD, Cable or Satellite Receivers, Amplifi er or Tuner, and Auxiliary devices. To do so, follow the instructions in “Programming a Device”. For best results, please read and follow all the remaining instructions. Keep this guide for future reference.

A Quick Look at Programming a Device

To control VCR or DVD, Cable or Satellite Receivers, Amplifi er or Tuner, and Auxiliary devices, follow these steps. Before proceeding, fi nd the codes for the devices you want to program in “Manufacturer’s Codes” on the right side of this page and write them down or highlight them.

To program a DVD Player, TV/DVD Combo, TV/VCR/DVD Combo, portable DVD player, or mobile DVD player, use the DVD key.

Turn on the device (for example, DVD player) and, if needed, load media (for example, a DVD).

Press a device key (VCR/DVD, CBL/ SAT, or AUX).

Press and hold SET UP until the red LED blinks twice; then release.

Enter the first five-digit code for your device. The LED blinks once as each digit is entered. If the code is correct, the LED blinks twice.

If the LED does not blink twice, repeat steps 2 to 4 and try entering the code again.

Aim the remote at the device and press . The device should turn off. If it does not, repeat steps 3–5, trying each code for your brand until you find one that works. If you cannot find a code that works, see “Searching for Your Code”.

Repeat steps 1–5 for the other devices you want to control. For future reference, write down each working device code below:

AUX Code:

CBL Code:

CD Code:

DVD Code:

SAT Code:

TNR Code:

VCR Code:

Press set to save and exit.

56