Programming Your Remote Control
Changing Volume Lock
The remote comes preset to allow independent volume control of each selected device (Global Volume Unlock). However, you may change the Volume Lock setting to Global Volume Lock so that one device’s volume will control volume in all other modes. After that, you can perform Individual Volume Unlock on a selected device to set its volume control for independent operation or Global Volume Unlock to remove all volume locking.
Locking Volume Control to One Mode (Global Volume Lock)
Press and hold SET UP until the red LED blinks twice; then release.
Enter
Unlocking All Volume Control (Restoring Global Unlock)
Press and hold SET UP until the red LED blinks twice; then release.
Enter
Volume is now independently controlled for all programmed devices.
Unlocking a Single Device’s Volume Control
Press a device key (TV, VCR/DVD, CBL/ SAT, or AUX).
Press and hold SET UP until the red LED blinks twice; then release.
Enter
Troubleshooting
PROBLEM | SOLUTION | ||
LED does not blink when you press a key. | Replace battery with new AAA size battery. | ||
LED blinks when you press a key, but | Make sure the remote is aimed at your device and is not more | ||
device does not respond. | than 15 feet away | ||
LED blinks one long blink. | An entry error has occurred (for example, wrong key). Try entry | ||
| sequence again. | ||
Remote does not control devices or | Try all listed codes for the device. Make sure the device operates with | ||
commands are not working properly. | an infrared remote control. | ||
CH▲, CH▼, and LAST do not work for your | Due to RCA design from 1983 to 1987, only the original remote | ||
RCA TV. | control will operate these functions. | ||
No volume on a device. | See “Changing Volume Lock”. | ||
Channels do not change properly. | If the original remote control required you to press Enter to | ||
| change channels, press Enter on this remote after entering the | ||
| channel number. | ||
|
| 58 |
|
|
|
| |