Setting TV Channels

4Adjust CHROMA (picture chroma) or PHASE (picture phase).

When an NTSC color bar signal is input:

1Adjust CHROMA (picture chroma) so that the blue bars on the left and right side of the screen have the same brightness.

2Adjust PHASE so that the two blue bars at the center of the screen have the same brightness.

3Repeat procedure 1 and 2 so that all four blue bars on the screen have the same brightness.

When a PAL color bar signal is input:

Adjust CHROMA (picture chroma) so that the blue bars on the left and right side of the screen have the same brightness.

*Refer to BASIC MENU OPERATION on page 14 for the adjustment procedure.

5After adjustment is complete, press the BLUE CHECK button again to turn the blue check function OFF (inactive).

This monitor is factory-preset to tune all VHF (2 to 13) and UHF (14 to 69) TV channels.

To perform the following, press the TV button to select TV.

When you want to reset the memorized TV channels, perform CH SEARCH START (initiate channel search) from the menu screen (refer to pages 14 and 15). The monitor automatically searches for broadcasting stations (VHF/UHF) and memorizes them.

You can also delete channels you do not want to watch. Select the channel to be deleted and perform CH SKIP ON (channel skip ON) from the menu screen (refer to pages 14 and 15).

*Channels deleted by CH SKIP ON (channel skip ON) cannot be tuned again. If you want to tune them, perform CH RESET ON (channel reset ON) from the menu screen to tune all VHF (2 to 13) and UHF (14 to 69) TV channels.

*In areas where the radio wave reception weak, searching for TV channels will not function well. In this case, perform CH RESET ON (channel reset ON) from the menu screen to tune all VHF (2 to 13) and UHF (14 to 69) TV channels.