8. Check and re‐check the Checksum. It should be 0x1E0A.
9. Press the Auto button right next to the read button. Check that the setting is according to picture above.
10.Press “Run”. The program will start to erase and reprogram the firmware. Sometimes the programming fails, if that happens, just restart the process by hitting “Run” again. When the ISP board is cold this can happen a couple of times before you get a successful run.
11.Disconnect the ISP board and connect the DVI cable from the monitor to the computer again. Make sure that there’s a video signal going to the screen. Locate the screens power supply. Press and hold the select button on the screen while you disconnect and reconnect AC power. The screen should show a message saying “All reset”. The screen will go into burn‐in mode if there’s no video signal. If you have problems getting a signal to the monitor you can do the reset after step 18.
LT1201 User Manual | 21 |