Mitsubishi Electronics LT-2240 Use of the Remote Control with Other A/V Products, Video Products

Use of the Remote Control with Other A/V Products

Programming the Remote Control

to Use with Other Brands of Audio

and Video Products:

(Figures 1-3 this page, figures 4-5 following page)

1.Move the slide switch at the top of the remote to the product you want to control.

2.Press and hold the POWER button on the remote control.

3.Enter the first three digit code listed for your equipment, and then release the POWER button on the remote control.

4.Point the remote control to the equipment and press the POWER button.

Note: If the equipment responds, the remote control is properly programmed to operate the equipment. If the equipment does not respond, repeat steps 2-4 with the next three digit code listed in step 3 for your equipment.

��					��	�����
��		����� ��� �����
	����� ��� �����			���� �� ������	�� ����
			���� ���� ���� ��������		����� ���
	������� ������������				���� �� ���
			���
	�������				������ �����
			���� ���� ���
	��������				������ ���
	���		���� ���� ���
					���� ��
			���� ���
	�������				��� �
			���� ���
	���������� �������				��������
	������		���� ���		��������
	�� ����� �� ������� ����� ����� ���
	Figure 1. Programming the remote to control your
	cable		box.

If you cannot turn the cable box ON by pressing POWER, try pressing CHANNEL or the number buttons.

��					��	�����
��			���������	�������� �����
	��������� �����			���� �� ������	�� ����
	���������� ��� �	���		���	���������
	�����������			���	��������
	������ � ���			���	���� �� ���
				���	������ �����
	��������� � ���				������ ���
				���
	��� � ���				���� �� ���
				���
	���� � ���				� ��������
				���� ���� ���� ���� ���
	�����������				��������
	�� ����� �� ������� ����� ����� ���

When set to TV, the PLAY, STOP, REW/REV, and

FF/FWD buttons will operate the VCR after the VCR codes have been properly programmed into the remote control.

Figure 2. Programming the remote to control your satellite receiver.

��			��	�����
��		��� �����
	��� �����	���� �� ������	�� ����
	����������	���� ���	���
		���� ���� ���	���� �� ���
	�������		������ �����
	���	���� ���
			������ ���
		���� ���� ���
	������� � ��������		���� ��
		���� ���� ���
	���������		��� �
	���	���� ���� ���
			��������
	����	���� ���� ���
			��������
	�������	���
	�� ����� �� ������� ����� ����� ���

Figure 3. Programming the remote to control your VCR.

27

LT2240_LT3040_OG_v6.ind27

04.1.21, 4:03 PM