Mitsubishi Electronics V29, V31 CHASSIS, V30+ specifications Error Codes

MODELS: WD-52627 / 52628 / 62627 / 62628 / 62827 / 62927 / 73727 / 73827 / 73927

Abnormal LED Indications

POWER	STATUS	LAMP	Power	Condition
LED	LED	LED	Status
Off	Yellow	Off	Low	Excess Temperature
			Power
Off or On	Off	Yellow	No	120w usage time over 7000 Hrs.
			change	150W usage time over 3500 Hrs.
Off	Off	Blinks	Low	Lamp Cover open
		Yellow	Power
Off	Blinks	Off	"	Filter Cover Open
	Yellow
Off	Off	Red	Stby	Lamp did not turn On
Off	Blinks	Off	Low	Fan Stopped
	Red		Power
Off	Red	Off	"	Circuit failure (short or DVI
				connector unplugged)

3. Error Code Operational Check

Note: The TV must be in “Shut Down” and not have been switched Off, to perform the Error Code Opera-

tional Check. When the TV is switched Off, the code automatically resets to “12” No Error.

Pressing the front panel “DEVICE” and “MENU” buttons at the same time, and holding for 5 seconds, activates the Error Code Mode. The LED flashes denoting a two digit Error Code, or indicating no problem has occured since the last Initalization.

Note: The front panel buttons must be used, NOT those on the Remote Control.

•The number of flashes indicates the value of the MSD (tens digit) of the Error Code.

•The flashing then pauses for approximately 1/2 second.

•The LED then flashes indicating the value of the LSD (ones digit) of the Error Code.

•The Error Code is repeated a total of 5 times.

Example: If the Error Code is “23”, the LED will flash two times, pause, and then flash three times.

4.Error Codes

The Error Code designations indicating malfunction, or no malfunction, are listed below:

Error Codes	"DEVICE" & "MENU"
Error Codes	Description
12	No error detected
22	Recovery from Reset
32	Lamp cover is Open
34	Lamp abnormality
35	DM Fan failed (Chassis Fan)
36	Exhaust or Lamp Ballast Fan failed
37	DMD Engine Fan failed
38	Lamp temperature abnormally high
39	DMD temperature abnormally high
41	Short is detected (Standby Power Supplies)
42	Lamp Fan failed
44	DVI cable between Format and Engine disconnected
46	DMD Fan failed (JC connector disconnected)
47	DM Temperature too high
48	Engine power supply short detected
51	Speaker Drive circuit short detected
52	HDD excess temperature (V30+ & V31 only)
55	HDD Fan Stopped (V30+ & V31 onlyt)

Page 39