JVC AV-36F704, AV-36FA44, AV-36FA54, AV-27FA54, AV-27FA44, AV-32FA54, AV 32FA44 manual Set Lock Code

Initial Setup

Set Lock Code

Channel guard and V-Chip settings are protected by a four-digit lock code. Your TV comes preset with a lock code of “0000”. You may change the code to any four-digit number you wish. To change the lock code, follow the steps below.

Press the MENU button

π† To SET LOCK CODE

è To operate (lock icon appears) Press ZERO to access the lock code

The first digit will be highlighted

√® To select the number π† To move to the next digit

� � � � � � � � � � � � � � � �

� � � � � � � � � � � � �

� � � � � � � � �� � � �

� � � � � �

� � � � � � � � � � �

� � � � � � � � � � � � � � � � � � � � �

Continue to follow these directions for all four numbers

π† To FINISH

è To save settings and exit (your lock code is now set)

Press the EXIT button when finished

When a viewer attempts to watch a blocked channel, this message appears:

������������������������

�������������������

�������������������������

������������������������

���������������������������

The channel will remain blocked until the correct lock code is entered (see above for information on setting your lock code).

Notes:

•After a power interruption you must reset the lock code.

•Write your lock code number down and keep it hidden from potential viewers.

•If you forget the lock code, a new code may be set using the steps listed above.

32