Proson RV 2200 manual Tuning to preset stations, Memory Backup Function

Select the desired preset number	Repeat the above steps 1 to 3 to mem-
3 (1~30) and press the MEMORY button.	4 orize other stations.

	MEMORY BACKUP FUNCTION
• When using the NUMERIC buttons on the remote
	The following items, set before the receiver is
control.
Examples) For “3” :	turned off, are memorized.
For “15” :	• INPUT SELECTOR settings
	• Preset stations,etc.
For “30” :	Note
• The station has now been stored in the memory.	• If the electricity fails or the AC input cord is dis-
	connected for more than several days, they are
• When using the NUMERIC buttons, the station is
	all cleared. So you should memorize them
stored automatically without pressing the MEMORY
	again.
button.

•A stored frequency is erased from the memory by storing another frequency in its place.

•If “MEM” goes off, start again from the above step 2.

Tuning to preset stations	Select the desired preset number.
	2
After selecting the tuner as an input
1 source, select the preset mode.
	• When using the NUMERIC buttons on the remote
	control.
	Examples) For “3” :
	For “15” :
	For “30” :
• Then “PRESET” lights up.	• To select numbers less than 10, press "0" and then
	the number. As an example, to select number 5,
	press "0" and "5". (Optionally, you may press just
	the number "5" and then wait a few seconds.)
Listening to FM stereo broadcasts	Scanning preset stations in sequence
• While listening to FM broadcasts,

• Each time this button is pressed,
the FM mode changes as follows:
• When FM stereo broadcasts are poor because of	• The receiver will start scanning the stations in the
	preset sequence.
weak broadcast signals, select the FM mono
	• At the desired station, press this button again to
mode to reduce the noise, then FM broadcasts
	stop scanning.
are reproduced in monaural sound.

13