JVC HR-XVC19BUS manual Connecting an Antenna or Cable TV, Basic TV Connections

Connecting an Antenna or Cable TV

aAntenna:

Disconnect the antenna from the rear of the TV and identify the antenna cable. If it is a round 75 ohm coaxial cable connect it directly to the jack marked ANT.IN on your DVD+VCR. If your anten- na cable is flat connect it to a 300-ohm to 75-ohm antenna adaptor (not supplied) and slip the adap- tor over the ANT.IN jack. Don’t attempt to screw it into to the DVD+VCR.

bCable TV:

If your cable connection has no converter or descrambler, unscrew the cable from your TV and attach it to the ANT.IN jack on the DVD+VCR. If a converter is required connect a coaxial cable from the wall jack to the IN connector on the converter, and a coaxial cable from the OUT connector on the converter to the ANT IN on your DVD+VCR. This cable hookup permits both TV and DVD+VCR operation.

Antenna Antenna

To view or record a CATV channel when using cable box

1.Tune the TV to the DVD+VCR output channel (CH 3 or 4).

2.Set the DVD+VCR channel selector to the cable output channel. (Example: CH3)

3.Select a channel using the cable converter.

Notes:

•With this connection, you cannot record one pro- gram while viewing another.

•If you are using a cable box to tune channels, it is not necessary to do Auto Channel Set.

Basic TV Connections

Make one of the following connections, depending on the capabilities of your TV.

Rear of TV

ANTENNA	VIDEO	AUDIO INPUT
INPUT	INPUT
		L	R

Preparation

OR	OR	V A1
	R

Rear of DVD+VCR

Rear of DVD+VCR

CA2

Pr	Pb	Y	R	L
COMPONENT/PROGRESSIVE SCAN			AUDIO INPUT
	VIDEO INPUT

Rear of TV

11