Sim2 Multimedia HT305 Memories, Save a Memory, Brightness Aspect Contrast, Color, Recall a Memory

MEMORIES

The main parameters of the image may be saved in distinct
1 VIDEO
groups of values (known as ‘Memories’); these parameters
2 S-VIDEO
can subsequently be applied all together by way of a single
3 COMP/RGB(YCrCb 15KHz)	3 COMP/RGB(RGB 15KHz)
command.	3 COMP/RGB(RGB)
3 COMP/RGB(YCrCb)
There are 3 distinct Memories (Memory 1, Memory 2, Memory
3) for each of the 8 signal types managed:
4 GRAPHICS RGB
5 HDMI

SAVE A MEMORY

To save the current values of the image parameters in Memory 1, use the È and Í keys to move to line ‘1’ and then open

the pull-down menu by pressing the Á/Ë key (Fig.39). Then select the option ‘Save current settings’. To confirm that the operation has been completed successfully, the message ‘Cur- rent settings saved in Memory 1’ is displayed at the bottom of the screen and the letter ‘S’ appears to the left of the memory name. The same procedure is used to save parameters in Memories 2 and 3.

making a total of 24 different available Memories.

The image parameters that can be saved/recalled by the Memories management system are the following:

Image	Picture
BRIGHTNESS	ASPECT
CONTRAST	COLOR TEMP.
COLOR	OVERSCAN
TINT	GAMMA
SHARPNESS
FILTER
SHARPNESS MODE
VIDEO TYPE
NOISE REDUCTION

Some of these parameters may not be available for certain inputs or certain input signals, as indicated in Tables 1 and 2. The menu page for the Memories management functions is activated by pressing the key on the remote control or the

key on the keypad (Fig.38).

20
05
	ZOOM	4	GRA
F1	2
1		CONTRO

Fig.38

The operations that can be performed on each memory se- lected are described here below.

Memories
0	Auto
1	S	Save current settings
2	I	Save initial settings
3	S	MEMORIARename 1
		Fig.39

RECALL A MEMORY

To recall a Memory, select the desired line and press Ë. The parameters saved in the selected Memory will be applied to the image displayed and a message will appear to confirm the operation ‘Memory 1 recalled’. The Memory recalled will be associated with the source and signal type, and will be automatically recalled every time that particular source and signal type combination is selected.

SAVE DEFAULT SETTINGS

To restore the original values to a previously modified Memory, select the line corresponding to the Memory in question and

open the pull-down menu ( Á key). Then select the line “Save default settings”. To confirm that the operation has been completed successfully, the message ‘Initial settings saved in Memory 1’ is displayed at the bottom of the screen and the letter ‘I’ appears to the left of the name of the memory.

RENAME A MEMORY

It is possible to assign a name to each Memory. To assign a name (with a maximum length of 12 alphanumeric characters) to a Memory, select the option ‘Rename’ from the correspond- ing pull-down menu. Enter the text following the procedure indi- cated in paragraph “source list”. informazioni, che tengono conto delle Memorie eventualmente selezionate nel penultimo accesso alla pagina ‘Memorie’.

25 RESTORE CURRENT SETTINGS