|
|
|
| EDITING EN 53 | |
| Audio Dubbing (DV Deck Only) |
|
|
| |
|
| ● Slide the TV/DVD switch to DVD. | |||
|
|
|
| ||
|
|
|
|
| |
|
|
|
| 1 Connect an audio device to the unit’s [AUDIO] input connectors | |
This function allows you to record new audio, without erasing the | |||||
original audio, on a DV tape that was recorded with ADV AUDIO |
| on the front panel. | |||
| ● When using a monaural audio device, connect its AUDIO OUT | ||||
RECB set to A12BITB (A pg. 59). |
| ||||
| connector to the | ||||
|
|
|
|
ATTENTION:
You cannot perform Audio Dubbing on a tape that was recorded with ADV AUDIO RECB set to A16BITB (A pg. 59), on a tape that was recorded at the ALPB speed, or on a blank tape.
Your unit | Recorder |
INPUT SELECT | AUDIO DUB. |
To [AUDIO] input
2 | Load a Mini DV cassette with the erase protection switch set to |
3 | ARECB. |
Press DV/HDD/DVD on the unit repeatedly or DV on the remote | |
4 | so that the DV lamp lights up on the unit. |
Press INPUT SELECT +/– on the remote control or | |
5 | INPUT SELECT on the unit to select |
Start playback slightly before the actual point from where you | |
6 | wish to start dubbing. |
Press W to pause playback. | |
7 | Press AUDIO DUB. to engage the audio dubbing mode. |
● Your unit enters the Audio Dubbing Pause mode. | |
● To perform Audio Dubbing with audio mixing, press AUDIO to | |
| select AL W X RB at this point. When using the DV deck as the |
| recording deck, also make sure that AAUDIO MODEB is set to |
| ASOUND1B (A pg. 59). |
Audio cable (not supplied)
AUDIO OUT
CD player, etc.
CD player, etc.
Mixer output
Original sound
Your unit | [AUDIO OUTPUT] |
Audio mixer
Recorder
| * Audio Dubbing with audio mixing is not possible if you are using a |
8 | monaural audio component, or if you don’t have an audio mixer. |
Engage the audio device’s playback, then press I to start the | |
| tape in the unit. Audio dubbing starts at this point. |
● To stop dubbing temporarily, press W. Press I to resume | |
9 | dubbing. |
Press o on the unit, then stop playback on the audio device to | |
| end the audio dubbing. |
NOTES:
●Once the Audio Dubbing starts, you cannot use the other deck.
●When monitoring the audio dubbed sound on the DV deck, set AAUDIO MODEB to ASOUND2B (A pg. 59).
●When playing back an audio dubbed Mini DV tape on the DV deck, set AAUDIO MODEB to ASOUND2B (A pg. 59).
●Audio dubbing is not possible using the [DV IN/OUT] connector.
●Audio dubbing is not possible on a blank portion of the tape.
To | INPUT SELECT | AUDIO DUB. |
|
| |
[AUDIO] |
|
|
input |
|
|