IR Emitter

Connecting an Audio/Video Distribution System

5Connecting an Audio/Video Distribution System

To configure a TP-9/TP-10audio/video distribution system (for example, for high quality home cinema system), as Figure 5 illustrates, do the following:

1.On the TP-9connect:

A composite video source (for example, a video player) to the CV IN BNC connector

A digital audio source (for example, the video player’s audio signal) to the AUDIO IN S/PDIF RCA connector

The IR OUT 2, 3.5mm mini connector to the IR receiver1 (on the video player) via the IR emitter cable (see Figure 4)

2.On the TP-10, connect the:

CV OUT BNC connector to a composite video acceptor (for example, a plasma display)

AUDIO OUT S/PDIF (digital audio) RCA connector2 to an audio acceptor (for example, the plasma display’s audio connector)

3.Connect the LINE OUT connector of the TP-9to the LINE IN connector of the TP-10, via UTP cabling (maximum range of up to 300ft (100m)).

4.On the TP-9underside, set the VIDEO switch to CV and the AUDIO switch to S/PDIF.

Note: Do not power the device ON when set to S/PDIF. First set the device to Analog mode, power on and then switch to S/PDIF if needed.

5.On each TP-9/TP-10unit, connect a 12V DC power adapter to the power socket and connect the adapter to the mains electricity (see section 3.1).

6.On the TP-10, if required, adjust the CV EQ. and level, by inserting a screwdriver into the small hole and carefully rotating it.

Figure 4: Connecting the IR Emitter

1 Stick the IR emitter to the IR receiver window (usually located on the front panel of the video player)

2 You can also connect either the AUDIO OUT ANALOG 3.5mm mini connector to an analog audio acceptor, or both AUDIO OUT connectors

8	KRAMER: SIMPLE CREATIVE TECHNOLOGY