Installation
Hardware Installation
Connecting to computer
ON OFF
NOTES
•Make sure you have a personal computer with an open USB port or IEEE 1394 port before connecting the drive to your computer.
•You cannot use the FireWire [IEEE 1394] and USB interfaces simultaneously.
OR
NOTES
To AC wall outlet.
•Power for all device should be turn off before attaching the cables.
Connect the drive to the computer as shown in figure.
1.Connect the USB converter cable [or IEEE 1394 cable] to the External Super Multi DVD Rewriter.
2.Connect the other end of the USB converter cable [or IEEE 1394 cable] to your computer.
3.Connect the AC adapter plug to the power connector at the rear of the drive.
Attach the AC adapter to the AC wall outlet.
4.When the computer is ready, confirm that the drive is detected. And then, insert the supplied software CD into the External Super Multi DVD Rewriter and install the software.
•Please do not turn off the drive while the computer is searching for the drive. If you turn off the drive, normal operation of the computer will not be possible.
•Please do not connect the AC adapter and USB 2.0 converter cable by any means other than specified above.
6