Connections to Your TV
Make one of the following connections, depending on the capabilities of your existing equipment.
When using the COMPONENT VIDEO OUT/ PROGRESSIVE SCAN jacks, set the VIDEO OUTPUT switch to COMPONENT. When using the SCART jack, set the VIDEO OUTPUT switch to RGB.
Tips
Depending on your TV and other equipment you wish to connect, there are various ways you could connect the recorder. Use only one of the connections described below.
Please refer to the manuals of your TV, VCR, Stereo System or other devices as necessary to make the best connections.
Caution
–Make sure the recorder is connected directly to the TV. Tune the TV to the correct video input channel.
–Do not connect the recorder’s AUDIO OUT jack to the phono in jack (record deck) of your audio system.
–Do not connect your recorder via your VCR. The DVD image could be distorted by the copy protection system.
Rear of TV
SCART INPUT
AUDIO INPUT | VIDEO | COMPONENT VIDEO INPUT | |||
|
| INPUT | |||
L | R |
| Y | Pb | Pr |
A V C T
Rear of the recorder
SCART connection
Connect the EURO AV1 AUDIO/VIDEO scart jack on the recorder to the corresponding in jacks on the TV using the scart cable (T).
Video connection
Connect the VIDEO OUT jack on the recorder to the video in jack on the TV using the video cable (V).
Component Video connection
Connect the COMPONENT VIDEO OUT/ PROGRESSIVE SCAN jacks on the recorder to the corresponding input jacks on the TV using an Y Pb Pr cable (C).
Progressive Scan connection
If your television is a
Connect the COMPONENT VIDEO OUT/ PROGRESSIVE SCAN jacks on the recorder to the corresponding in jacks on the TV using the Y Pb Pr cable (C).
Notes:
Set the Progressive to [ON] on the setup menu for progressive signal, see page 19.
Progressive scan does not work with the analog video connections (yellow VIDEO OUT jack).
Caution
Once the setting for Progressive Scan output is entered, an image will only be visible on a Progressive Scan compatible TV or monitor. If you set Progressive Scan to [ON] in error, you must reset the recorder. First, remove the disc in the recorder. Next, press STOP (x) and hold it for five seconds before releasing it. The video output will be restored to the standard setting, and a picture will once again be visible on a conventional analog TV or monitor.
Audio (Left/Right) Connection
Connect the left and right AUDIO OUT jacks of the recorder to the audio left and right IN jacks on the TV using the audio cables (A). Do not connect the recorder’s AUDIO OUT jack to the phono in jack (record deck) of your audio system.
12