LG Electronics 30FZ1DC, 32FZ1DC-UB owner manual Programming the Remote

Programming the Remote

The remote control for your HD receiver is a multi- brand or universal remote control. It can be pro- grammed to operate most remote-controllable devices of other manufacturers.

Note that the remote control may not control all models of other brands.

1	Test your remote control.
	To find out whether your remote control can
	operate the component without programming,
	turn on the component such as a VCR and press
	the corresponding mode button (VCR) on the
	remote control, while pointing at the compo-
	nent. Test the POWER and CH +/- buttons to see
	if the component responds properly. If not, the
	remote requires programming to operate the
	device.
2	Turn on the component to be programmed, then
	press the corresponding mode button on the
	remote control.
3	Press the POWER and MUTE buttons simultane-
	ously, the remote control is ready to be pro-
	grammed for the code.
4	There are two ways to find the right code for the
	component.
	A. If you press the CH +/- buttons repeatedly,
	the codes will change one at-a-time. Press the
	POWER button after each code change. If the
	right code is found, the device will turn off.
	B. Enter a code number using the number but-
	tons on the remote. Programming code num-
	bers for the corresponding component can be
	found on the following pages.
	Again, if the code is correct, the device will
	turn off.
5	Press the EXIT button to store the code.
6	Test the remote control functions to see if the
	component responds properly. If not, repeat

from step 2.

2

4

3

TV	VCR CABLE	DVD SAT
MODE	TV/VIDEO	POWER
VIDEO1	VIDEO2	FRONT
COMP1	COMP2	HDMI

1	2	3
4	5	6
7	8	9

DASH(-)	0	FLASHBK
MUTE		FAV
EZ SOUND		EZ PIC
VOL		CH

RATIO FREEZE SAP SURROUND

INFO TIMER CC SIGNAL

MENUEXIT

PLAY PAUSE STOP RECORD

REW FF

SKIP

3/4

4

5

P A G E 4 7