LG Electronics RU-48SZ40 owner manual Programming the Remote, Test your remote control

Programming the Remote

	The remote control is a multi-brand or universal
	remote control that can be programmed to oper-
	ate most remote-controllable devices of other
	manufacturers.
	Note: The remote control may not be able to con-
	trol all models of other brands.
1	Test your remote control.
	To find out whether your remote control can
	operate the device without programming,
	turn on the device such as a the VCR and
	press the corresponding MODE button (VCR)
	on the remote control while pointing at the
	device. Test the POWER and CH +/- buttons
	to see if the device responds properly. If
	not, the remote requires programming to
	operate the device.
2	Turn on the device to be programmed. Then
	press the corresponding MODE button on
	the remote control.
3	Press the MENU button and the MUTE but-
	ton simultaneously. Now the remote control
	is ready to program the code for the corre-
	sponding device.
4	There are two ways to find the right code for
	the device.
	A. If you press the CH +/- buttons repeat-
	edly, the codes will change one at a time.
	Press the POWER button after each code
	change. If the right code is found, the
	device will turn off.
	B. Enter a code number using the number
	buttons on the remote. The right code num-
	bers for the corresponding component can
	be found on the following pages.
	Again, if the code is correct, the device will
	turn off when you press the POWER button.
5	Press the MENU button to store the code.
6	Test the remote control functions to see if
	the device responds properly. If not, repeat

from step 2.

2

4

3

3/5

HT	MODE	POWER
LIG
TV/VID	FRONT	COMP/DVI
EO

ENTER	FLASHBK
MUTE	SURF
VOL	CH
CC	AVL
RATIO	SLEEP

ENTER

MENU			EXIT
	VIDEO	AUDIO
PLAY	PAUSE	STOP	RECORD
REW	FF	SKIP
PIP	PIP ch-	PIP ch+	PIPinput
FREEZE	SAP		SWAP

4

4

P A G E 4 7