Basic Installation, Switching On TV Set

BASIC INSTALLATION

Switching On TV Set

1)If stand-by indicator is red, then the TV set is in stand-by mode. You can switch on using the remote control POWER button (A1), the NUMBER 0… .9 buttons (A3), or PROGRAM UP (A6) / DOWN (A21) buttons. The front panel PROGRAM UP/DOWN buttons can also be used.

Once on, the stand-by indicator turns off and the picture appears on the screen.

2)If stand-by indicator is not lit, then the TV set is powered off. You must press the TV set front panel MAIN POWER button.

If a picture does not appear, then the stand-by indicator will be lighted red. In this case, use the remote control as indicated in 1).

3)If stand-by indicator is flickering then the TV set is in child-lock mode.

It is necessary to use the remote control POWER button (A1), NUMBER 0… .9 buttons (A3), or PROGRAM UP (A6) / DOWN (A21) buttons. The Top panel PROGRAM UP/DOWN buttons will not function. Once on, the stand-by indicator turns and the picture appears on the screen.

SWITCHING OFF TV SET

1)Pressing the remote control POWER button (A1), you can switch off to stand-by mode (low power consumption mode) which also allows quick restart by remote control (see above: SWITCHING ON TV SET).

2)Pressing the TV set front panel MAIN POWER button, you can completely power off the TV set. In this case, you must use the same front panel POWER button to switch on again (see above: SWITCHING ON TV SET).

Remark: If a broadcast signal is not present after 30 minutes, the TV set will be automatically turned to stand-by mode.

Automatic Tuning

ATSS = Automatic Tuning and Sorting System.

To start the ATSS function :

1)Press the MENU button (A19), then select the INSTALL menu by using Remote control CURSOR UP (A6), DOWN (A21) buttons.

2)Press and hold the OK button (A18) to start the automatic tuning.

The ATSS function has started when the phase “Please Wait!” appears (in red characters) in the help instructions box, below the install menu. when the ATSS function is finished, the stored programs are displayed on screen using Edit menu presentation (to exit tuning before automatic tuning is finished, press the remote control MENU button (A19)).