Battery Installation and Replacement
The remote control is powered by two 1.5V AAA batteries. To install or replace batteries:
1. Open the battery cover of the remote control by pushing and pulling it in the direction of the arrow.
2.Insert two new “AAA” size batteries
for the remote control. When replacing old batteries, push them towards the springs and lift them out.
3.Match the batteries to the (+) and
marks in the battery compartment.
4. Insert the bottom of the battery, the
first, push towards the springs and
insert the top of the battery, the (+) side, into place. Do not force the battery into the battery compartment.
5.Close the battery cover making sure the tabs rest in the corresponding holes and push down the cover until it clicks shut.
CAUTION: Incorrect usage of batteries can result in leaks or bursting. NEC recommends the following battery use:
•Do not mix battery brands.
•Do not combine new and old batteries. This can shorten the battery life or cause liquid leakage of the batteries.
•Remove dead batteries immediately to prevent battery acid from leaking into the battery compartment.
•Do not touch exposed battery acid as it may injure skin.
•Remove the batteries if you do not intend to use the remote control for a long period of time.