Remote Control (Continued)
PREPARING THE REMOTE CONTROL
To operate the combo player, you must first place the batteries in the remote control.
1 | 2 |
| 3 |
Open the cover. |
| Insert batteries (AAA size). | Close the cover. |
Make sure to match the + and - on the batteries to the marks inside the battery compartment.
OPERATING WITH THE REMOTE CONTROL
Operating player with the remote control.
|
| The remote control must point at the remote sensor in order for |
|
| the remote to function correctly. |
|
| Distance: Maximum of 7 m from the front of the remote sensor. |
3 0 | 3 0 | Angle: Approximately 30° from each direction. |
*Do not place the remote control under intense light source such as direct sunlight.
BATTERIES
INCORRECT USE OF BATTERIES MIGHT CAUSE THEM TO LEAK, CORRODE OR EXPLODE.
•Do not place the batteries in the wrong direction.
•It is dangerous to charge, heat, open, or
•Do not leave dead batteries or mix new with old batteries in the remote control.
•When not using the remote control for a long duration of time, remove the batteries. When operating range becomes reduced, replace batteries.
•If battery leakage occurs, wipe the battery liquid from the battery compartment, then replace batteries.
REMOTE CONTROL
• The remote control should be aimed directly towards the remote sensor of the combo player.
Connecting With TV
When connecting the RF cable to your TV, set your TV to channel 3 or 4 depending on how your TV was originally set up for video inputs.
HOW TO CONNECT WITH RF CABLE OR AV CABLE
1.Using an RF or AV cable, plug one end of the cable into the cable TV outlet on your wall and the other end into the "ANT.IN" jack on the rear of the Combo Player.
2.Using another RF or AV cable, plug one end of the cable to the "RF OUT" jack on the Combo Player and the other end of the cable to the "ANT.IN" jack on your TV.
3.Using RCA cables, connect the red, white and yellow ends to the corresponding
By using RCA cables you will enjoy cleaner audio and video.
6