FRONT PANEL CONTROLS
FIRST TIME USE
Plasma Television “MAIN POWER” switch
This power switch is for the complete system, and must be turned ON/OFF manually. It is recommended to leave the “MAIN POWER” to ON condition (lights red) for
POWER light indicator
To turn the monitor ON, press the main power switch located on the lower right side of the monitor. A red
Indicating lamp
Indicating | Power status | Operating | |
lamp | |||
|
| ||
|
|
| |
Off | Off | When the main power switch is set | |
to OFF. | |||
|
| ||
|
|
| |
|
| When the main power switch is | |
| Off | ON, and the POWER button on the | |
Lights red | remote control or the SUB POWER | ||
(standby) | |||
| button on the underside of the | ||
|
| ||
|
| front of the frame is OFF. | |
|
|
| |
|
| When the main power switch is | |
|
| ON, and the POWER button on the | |
Lights green | On | remote control or the SUB POWER | |
|
| button on the underside of the | |
|
| front of the frame is ON. | |
|
|
| |
|
| When the main power switch is | |
|
| ON, and the POWER button on the | |
| Off | remote control or the SUB POWER | |
Lights orange | button on the underside of the | ||
(Power Save) | |||
| front of the frame is ON. | ||
|
| However, the status will be in | |
|
| POWER SAVE mode when in RGB1 | |
|
| or RGB2 input. | |
|
|
|
NOTES: 1. Your HITACHI Plasma Television will appear to be turned OFF (lights orange) if there is no video input when RGB1 or RGB2 is selected. Check the Power Light to make sure the Plasma Television is turned off or in
2. Remote Control can not turn ON/OFF the “MAIN POWER” of the Plasma Television.
REMOTE CONTROL sensor
Point your remote at this area when selecting channels, adjusting volume, etc.
With in 30
With in 30 degrees degrees
About 3m | About 3m |
About 5m
1 2 3
4 5 6
7 8 9
0
12