Hitachi P50H401A, P42H4011 Remote Control for Cable Box Functions, Cable Brand Analog Type Codes

Control

OPERATING THE PRECODED

FUNCTION FOR YOUR CABLE BOX.

This remote is designed to operate different types of cable boxes. You must first program the remote to match the remote system of your cable box (refer below for pre-codes).

1.Turn ON your cable box.

2. To switch to Cable (CBL) pre-coded mode, press and release the CABLE (CBL) button.

3. Hold down the CBL button on the remote and enter the two digit preset code that matches your cable box, as shown below. Release the CBL button.

￿ ￿

￿

￿

The Remote

4. Aim the remote at the cable box and press the POWER button. The remote will turn off your cable box when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your cable box. If the cable box does not turn off, try a different two digit preset code.

5. The remote will now control your Cable box.

NOTE: 1. If your cable box cannot be operated after performing the above procedures, your cable box code has not been precoded into the remote.

2.In the unlikely event that your cable box cannot be operated after performing the above procedures, please consult your cable box operating guide.

3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.

￿CABLE (CBL) button

This button allows the remote to control your cable box by setting it to CABLE mode.

￿PRECODED CABLE BOX buttons

These buttons transmit the chosen precoded cable codes.

￿EXCLUSIVE TV buttons

These buttons are for operating the TV.

￿

￿

NOTE: Refer to instruction manual of the Cable Box for operation of the buttons exclusively for the Cable Box.