Chapter 3 Using the LCD TV
Chapter 3
USING THE FEATURES
Tuning in the TV channels
After connecting an aerial to your LCD TV and connecting the mains cable to the TV and 230VAC mains socket, turn the POWER SWITCH of rear TV on, a red light will show on the front centre panel of the TV.
Press the POWER button, the red light will change to green and the First Time Installation screen will show:
1.Make sure an aerial is fitted then press OK button on the remote to start the Auto Programme Scan (APS).
2.In a short while you will see the TV programmes briefly as each channel is received and stored in the memory. When APS is completed BBC1 digital TV will show, press CH+/- buttons to view the other channels stored.When finished ATV scan.TV will Auto change to DTV do the first installation channel. To view analogue TV press INPUT button and
use the up / down arrow buttons to select TV and then Press the OK button.Change channels by pressing the CH +/- buttons.
To power off press the POWER button, the green light will change to red.
Selecting a INPUT
Press the INPUT button to display the function required (TV/AV).Using the arrow buttons
on the remote highlight the function required and press the OK button to select the function.
Select TV Channel
Press the CH.+/- button on the remote control and the
You can directly select the TV channel required by pressing 1,2 or 3 etc on the remote button pad.
Adjusting the Volume
Press the VOL. +/– button on the remote control or the VOL. +/- button on the LCD TV to adjust the volume.
To Mute the Sound
Press MUTE and the sound cuts off.
To turn mute off, press the MUTE button again, or simply press the VOL +/- button.
Sleep Timer
Press the SLEEP button continuously to select the sleep timer or turn the sleep timer from the OFF,15,30,60minutes; when the LCD TV has reached the set time, it will automatically turn off. If the TV has no input signal, it will automatically power down to standby after 15 minutes.
21