Magnavox 55P916, 60P916, 64P916 manual Select Channel Memory ADD/DELETE Channels control

FEATURE MENU CONTROLS (CONTINUED)

ADD/DELETE CHANNELS

Auto-Programming (see previous page) adds all the

channels it can find (on your Antenna or Cable TV system) into the TV's memory. Add/Delete Channels makes it easy for you to add other channels, or drop unwanted channels, from the list of channels in the TV's memory.

BEGIN

1Select CHANNEL MEMORY (ADD/DELETE CHANNELS) control.

With the FEATURES MENU on screen, move the RED highlight with the outer MENU ring buttons. Then press the center MENU button to select the feature.

2Press the CHANNEL ▲▼ or number buttons to select the channel you want to add or delete.

3Press the outer MENU ring button (on the Right) to

ADD the channel into the TV's memory.

Press the outer MENU ring button (on the Left) to DELETE the channel from memory.

Repeat steps 2 and 3 for each channel you wish to add or delete.

4Press the STATUS or MENU button to clear the screen when through.

STOP

SMART HELP

Remember. You can also add the Auxiliary modes

(AUX 1 VIDEO, AUX 1 Y PB PR, etc.) just like a channel. Then by pressing the CHANNEL ▲▼ buttons the AUX(iliary) mode can quickly be selected to use the desired set of Input jacks (see page 33).

Note: AUX(iliary) VIDEO modes are located between the lowest and highest channel numbers within the ADD/DELETE CHANNEL control screen.

MAIN MENU
PICTURE		SOUND
FEATURES		HELP
1ST TIME SETUP		EXIT
AV	POWER

GUIDE INFO

	TV	VCR	ACC	1
	SWAP	PIP CH	SOURCE
		DN UP
4	SLEEP		AUTO
	STATUS/		MENU/
	EXIT		SELECT
	VOL		CH	1	3
		MUTE
	1	2	3
	4	5	6		2
	7	8	9
	100+	0	SURF
	POSITION		PIP

FEATURE MENU
PICTURE	CABLE
SOURCE	TUNING
CLOSED	CHANNEL
CAPTIONS	MEMORY
EXIT	MORE...
	1 OF 5

CHANNEL MEMORY
ADD/DELETE
CHANNELS
START
AUTO-PROGRAMMING
EXIT	HELP

ADD/DELETE CHANNEL

Channel 19 Added for ANT A

SELECT CHANNEL

to DELETE CHANNEL

AB for ANT B

M when FINISHED

NOTE: A separate ADD/DELETE CHANNEL memory may also be created for the ANT(enna) B Input on the rear of the set (if an Antenna or Cable TV signal has been connected). Press the “AV” button on the remote, while in the ADD/DELETE CHANNEL mode, to switch between the ANT A and ANT B channel memory lists. Then follow steps 2 and 3 as shown to the left to add or delete the desired channels.

14