Magnavox MRD-200 First Time Setup, Where Do You Start?, Battery Installation, Antenna Connections

Page 9
Replace the battery compartment lid.

Where Do You Start?

1 Disconnect all equipment from power. Connect equipment to power only after you have finished hooking up everything. Do not change connections with equipment connected to a power outlet.

2 Put the batteries in the remote control and connect the AM and FM antennas as detailed below.

3 Connect the DVD Receiver to a Television using one of the options detailed in your separate Quick-Use Guide (or on pages 10-12).

You need only one video connection between the DVD Receiver and the TV. Use Composite Video (good picture quality), S-Video (better picture), or Component Video (best picture). Use the best connection available with your TV.

Set the TV to the correct VIDEO IN channel. Such channels may be called AUX(iliary) IN, AUDIO/VIDEO (A/V) IN, EXT1, S- VIDEO, etc. These channels are often near channel 00 on your TV. Or, your TV remote control may have a button or switch that chooses different Video modes. With some TVs, you use the TV’s menu to select a Video mode. See your TV manual for details.

4 Connect the speakers and Subwoofer to the DVD Receiver

as detailed in your Quick-Use Guide (or on page 13).

Battery Installation

1 Remove the battery compartment lid by pressing in the tab, then lifting off the lid.

2 Place the batteries in the battery compartment, matching the +/- markings on the batteries to the +/- markings inside the remote.

3

Antenna Connections

1 Connect the supplied AM loop antenna to the AM jack on the rear of the DVD Receiver.

Reposition the loop antenna to receive the clearest sound for area stations. Attach the antenna to the base stand if desired.

First Time Setup 9

Note: If your TV only has a single Antenna In(put) jack, you will need an accessory RF

Modulator to view the DVD playback on your TV. See your electronics retailer or contact Magnavox for details on RF Modulator avail- ability.

75 ￿

Rear of TV

Put the claw into the slot.

2 Connect the supplied FM antenna to the FM jack on the rear of the DVD Receiver. Extend and adjust the antenna until the clearest station signal is received. For better FM reception, use a 75 ohm coaxial cable (not supplied) to connect the DVD Receiver to an outdoor FM antenna as shown.

OR

AM

FM

(75 Ω)

Outdoor FM

Antenna

(not supplied)

Helpful Hint

To prevent unwanted noise, keep the antenna as far away as possible from the TV, VCR, or any other radiation source.

Image 9
Contents User guide Model No Serial No Warranty VerificationTable of Contents Installation Safety InformationCopyright Protection Federal Communications Commission FCCIntroduction Remote Control Front Panel Rear Panel AC Power cordConnect an additional center speaker not supplied here Connect to a standard AC outletWhere Do You Start? First Time SetupBattery Installation Antenna ConnectionsHookups TV Connecting to a TV with a Composite yellow Video In JackConnecting to a TV with Component Video In Jacks Hookups TV cont’dSet Video OUT to PR PB Y. Details are on Connecting to a TV with an S-Video In jack Hookups Speakers Connecting the SpeakersHookups Optional Connecting to a TV and Optional Audio EquipmentANT To TV Connecting to a VCR or Cable/Satellite BoxDVD Disc Menus Quick Disc PlaybackTurn on your TV and set it to the correct Video In channel To stop playback at any time, press Stop CPausing Playback Playback FeaturesSystem Menu System Menu IconsTo exit, press System Menu or OK Subtitles Subtitles, Audio LanguageAudio Language Press System Menu to remove the Menu BarSlow Motion Slow Motion, SearchingSearching Press 9 to select a Slow Motion speedTitle/Chapter Selection Title/Chapter Selection, Time SearchTime Search Use the Number buttons 0-9 to select a Title or ChapterStatus, Zoom StatusZoom Angle Angle, StepStep Picture will change to the angle you selectedMP3 Features Playback Control, MP3 FeaturesPlayback Control Video CD only Press 9 to select PBC on or PBC OFFRepeat Repeat, Repeat A-BFavorite Track Selection TV System NTSC, PAL While playback is stopped, press System MENU. Press TV ShapeMat. Check the Disc case for details Press System Menu to remove the menuScreen Saver Screen Saver, Video OutVideo Out Or to select Icon Press 9 to select Then pressNight Mode Digital Output, Night ModeDigital Output Set Digital Output according to your audio connectionChoose Rear Delay if Speaker SettingsFront Left & Right speakers Choose Test Tone if youDVD Audio, Subtitle, and Disc Menu Languages Language SettingsPress the Number buttons 0-9 on the remote control to Parental Control LevelsParental will be selected. Press Parental Control Password Parental Control Password, DefaultsDefaults Bly viewed previously blocked or restricted level materialAdjusting the Volume Audio and Sound FeaturesChanging Surround Speaker Volume Levels Selecting Digital Sound EffectsSelecting Surround Sound Surround Sound OptionsSelecting Preset Radio Stations Tuning Radio StationsRadio Stations Programming Radio StationsSleep Timer Helpful Hints Helpful Hints cont’d Specifications are subject to change without notice SpecificationsFront speakers/ Rear surround speaker Center SpeakerPR PB Y See Component Video Out Jacks GlossaryIndex Limited Warranty Limited Warranty