Changing Input Source, Changing Channels

Using the TV

Notes

•Unless the TV is not going to be used for an extended period of time, the main power switch can be left in the ON position without consuming a lot of power.

•After you switch off the TV, the power LED flashes red/green for 10 seconds, flashes red for approximately 40 seconds and then turns red when the system is powered off. When the LED is flashing red, the TV is in its final cooling phase and the system will not respond to any commands from the remote control or front panel buttons. Wait until the power LED stops flashing for about 1 minute before switching on the TV again.

English

Changing Input Source

After switching on the TV, select the appropriate input source using the front panel buttons or the remote control as follows:

•Press ATV, DVI/HDMI, YPbPr, DTV, AV, SV, or VGA on the remote control to switch to the respective input.

•Press the ENTER/SOURCE button on the front panel of the TV repeatedly to switch through all the input sources.

•Press SOURCE on the remote control to select the source from the on-screen menu. A list of input sources is displayed on the screen. Select the appropriate input using the cursor keys and press OK on the remote control to display the input signal.

Input Select

EXIT

ATSC

Analog TV

AV1

AV2

AV3

AV4

HDMI

VGA

Front

Changing Channels

Use one of the following methods to change channels:

•Press the channel up or down buttons on the front panel or the remote control to switch to the previous or next channel.

•Press the number keys on the remote control to directly key in a channel number.

Adjusting Volume

To adjust volume, do the following:

•Press the volume up or down buttons on the front panel or the remote control to increase or decrease the volume.

•Press the mute button (see page 4) to disable the volume. Press the button again to restore sound.