Troubleshooting __ Watching DVD
If you experience the following problems while using the unit, this | troubleshooting guide can | |
help you. |
|
|
No sound | ● Check if the unit is | connected securely. |
| ● Make sure the TV or amplifier is working properly. | |
| ● Make sure the amplifier is set to receive DVD | |
| signal output. |
|
No image | ● Check if the unit is connected securely. | |
| ● Make sure the TV is working properly. | |
| ● Make sure the color system is set correctly. | |
Bad sound quality | ● Make sure the audio output mode is set correctly. | |
| ● Make sure the audio connection between the | |
| unit and amplifier is in place. | |
Disc cannot be played | ● There is no disc in the unit. | |
| ● Put the disc on the disc tray properly with the | |
label side up. ● Clean the disc.
● Moisture has condensed in the unit. Remove the disc and leave the unit on for about an hour.
The unit doesn’t operate
normally
Remote control does not work
●Disconnect the power plug and insert it into the wall outlet again.
●Remove barriers between the remote control and the unit.
●Point the remote control at the remote control sensor of the unit.
●Replace the batteries with new ones.
This product incorporates copyright protection technology that is protected by method claims of certain U.S. patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corporation, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited.
page38