SETTING THE REMOTE CONTROL TO OPERATE ACCESSORY DEVICES
SEARCH METHOD
Your TV remote can be set to work various
external devices such as VCRs, Cable Boxes, Satellite Receivers, DBS, DVD Players, etc., by using the search method of remote control programming.
If the Code Entry method shown on the previ- ous page did not set your remote to work your external device, then follow the easy steps listed below.
Please read steps
1 Press the POWER button on the accessory device to turn it ON.
2 Place the TV/VCR/ACC Mode Switch in the proper position for the device you want to operate.
3 Press and hold the A/CH • RECORD and SMART SOUND buttons simul- taneously.
4 The device will begin to change chan- nels after the remote identifies the cor- rect code. When the channels start to change, release the A/CH • RECORD and SMART SOUND but- tons. The remote should be ready to operate the device.
HELPFUL HINT
This method can take up to two minutes to perform.
Don’t let the device scan up more than five channels. If you do, the remote may pass up the right code and another two minute search cycle will have to be repeated.
If no channel change happens within two minutes, repeat steps
Satellite Receiver |
|
|
|
| |||
1 Cable Converter |
|
|
| 070809 06 | 07 | ||
|
|
|
| 06 | 0708 | 0809 | |
|
|
|
|
|
|
| |
VCR |
|
|
|
|
| 09 | |
2 |
|
|
|
|
| ||
| SLEEP |
|
|
| POWER | 4 | |
|
| A/CH | STATUS/EXIT | CC | CLOCK | ||
| TV |
|
|
|
| TV/VCR | |
| VCR | 1 |
| 2 |
| ||
|
|
|
| 3 |
| ||
| ACC |
|
|
|
|
|
|
|
| 4 |
|
|
| 6 |
|
|
| 7 |
| 8 |
| 3 |
|
|
| SMART | 0 |
|
| ||
|
| MENU |
|
| |||
3 |
| VOL |
|
|
| CH |
|
|
|
| MUTE |
|
|
| |
NOTE: The remote is for use with exter- nal accessory devices only and not for use with other brands of TVs.
31