Gefen EXT-DVIDL-2-HDMIR user manual Panel Descriptions, Power LED Indicator

Page 8

PANEL DESCRIPTIONS

1Power LED Indicator

This input indicator will become active once the included 24V DC power adapter has been properly connected to a power source.

2Reset Button

This button will reset the unit and force all input/outputs to re-initialize.

3Active Link LED Indicator

This LED indicator will activate once a link has been detected from the source device to the output device.

410-Bit/12-Bit Selector Switch

This switch will set either the 10-bit or 12-bit color modes. This switch is only active when the Main Switch is in the ON position.

5Master Switch

This switch will enable/disable the use of the extended color modes switch;

10-Bit/12-Bit Selector Switch

6HDMI Output

This port will accept a single HDMI capable output device via an HDMI type A connector.

7DVI-DL Input

This port will accept a single DVI-DL (proprietary signal) input device via a DVI-I type connector.

824V DC Power Input

This input will accept power from the included 24V DC power supply. Connect the power supply to the unit and an available power source.

5

Image 8
Contents DVI DL to Converter Asking for Assistance Technical SupportTechnical Support Hours Write ToContents Introduction GefenOperation Notes Features Package IncludesPanel Layout 3 3Power LED Indicator Panel DescriptionsHow to Operate the DVI DL to Hdmi Converter Connecting and Operating the DVI DL to Hdmi ConverterHow to Connect the DVI DL to Hdmi Converter Specifications Warranty Product RegistrationPage Page Rev A4 Nordhoff St., Chatsworth CA