Additional Programming Options, Setting TV Control

ADDITIONAL PROGRAMMING OPTIONS

Locate the three position switch within the battery compartment. Set the switch to the middle position P to enter programming mode.

When programming is complete, set the switch to either CHILD mode or ADULT mode before replacing the battery compartment door.

SETTING TV CONTROL

TV control can be set by inputting the code for your brand of TV or via a simple code search. Setting TV control by code input is described in the Quick Start on page 4.

Setting TV Code by Code Search

1.With your television ON, and the remote in Programming Mode, press the CHkey. The LED blinks twice.

2.Press the ON/OFF key once.

3.Press the CH key once per second until the TV turns off.

4.Press ON/OFF. If the TV turns on, press MUTE

to save the TV code.

5. If the TV does not turn on, press CH to go to the previous TV code and press MUTE to

save once the TV turns on.

NOTE: There are over 200 possible codes, so this may take a few minutes.

RE-PROGRAMMING FAVOURITE CHANNEL KEYS

MiniMote comes pre-programmed with 8 favourite kids channels assigned to keys 3 through 0 (refer to Key chart on Page 7). The preprogrammed buttons can be programmed to new channels by following the steps below.

CAUTION: This will program over the channel that was pre-programmed!

To program a favourite channel, follow these steps:

1.While in Programming Mode, press and hold the key that you wish to assign a favourite channel. Release the key when the LED blinks twice.

2.Press the digits for the channel number for the favourite channel that you wish to add.

3.Press and hold the key that you wish to assign again until the LED blinks twice.