Disc Operations
To interrupt playback
●Press ÉÅ.
➜ To resume normal playback, repeat the above.
To stop playback
●Press Ç.
➜ If the system remains in stop mode for 30 minutes, it will switch to Eco Power standby mode.
Repeat and Shuffle
You can select and change the various play modes before or during playback.
Repeat play
1Press REPEAT on the remote repeatedly to select :
A |
| D |
B |
| E |
C |
|
|
|
|
|
A – to repeat playback of the current track. B – to repeat playback of the current disc. C – to repeat playback of all available discs. D – to repeat playback of the current
programmed track (only if the programme mode is active)
E – to repeat playback of all the programmed tracks (only if the programme mode is active)
Programming the disc tracks
Programming tracks is possible when playback is stopped. Up to 40 tracks can be stored in the memory in any order.
3 |
|
1 |
|
4 |
|
6 |
|
DISC 1 |
|
7 |
|
2 , | 5 |
1Load the desired discs on the disc trays (refer to “Loading discs”).
2Press PROGRAM (PROG) to start programming.
➜ PROG starts flashing.
3Press CD or one of the CD 1~5 buttons to select a disc.
4Press í or ë repeatedly to select the desired track.
5Press PROGRAM (PROG) to store.
●Repeat steps
➜Skip step 3 if you are selecting tracks from the same disc.
➜If you attempt to programme more than 40 tracks, "PROGRAM FULL" is displayed.
E n g l i s h
2To resume normal playback, press REPEAT until "OFF" is displayed.
Random play
●Press SHUFFLE on the remote to turn on/off the shuffling mode.
➜If activated, SHUF is shown and the repeat mode (if any) will be cancelled.
➜All the available discs or programmed tracks (if programme is active) will be played in random order.
Note:
–Pressing the OPEN•CLOSE button will cancel all repeat and shuffling modes.
6To start programme play, press ÉÅ.
7To stop playback or to end the programming, press Ç once.
➜ PROG stays and the programme mode remains active.
Notes:
–If the total playing time reached 100 minutes or if one of the programmed tracks has a number greater than 30, then
–The system will exit programming mode if no button is pressed within 20 seconds.
19