ViewSonic VPW450HD manual Connecting a PC, Using RGB or DVI Video Input

Connecting a PC

Using RGB or DVI Video Input

1.For most PC’s, connect the 15-pin D-Sub RGB connector from the back of the PC to the RGB-IN Connector located on the back of the display. If you have a PC that is equipped with a DVI (Digital Visual Interface), you may connect the PC DVI connec- tor from the back of the PC to the DVI-In Connector located on the back of the display.

2.Connect the red (R) and white (L) audio jacks from the PC to the R and L jacks located to the left of the S-VIDEO connector. If you are using a DVI interface, simply connect the (R) and (L) audio jacks to the R and L jacks located to the left of the VIDEO

1connector.

Notes:

„Your PC may have audio jacks in the form of a 3.5mm phono plug. If this is the case, you will need to use a phono-plug to RCA converter cable in order to connect audio.

„A RGB loop-out labeled “RGB Out” will allow another RGB display to be connected. The RGB loop-out will display the same signal as the RGB In signal source.

„The physical display resolution is a maximum of 1024x768 dots when aspect ratio is set to “4:3”, and 1366x768 dots when set to “16:9”. If the PC’s display resolution exceeds these maximums, the display will have to artificially eliminate dots in order to fit within the physical dot capability of the display; therefore, it is possible that the display may not be able to show details with adequate clarity.

ViewSonic VPW450HD 9