Esoteric D-01 manual Changing the Settings, Restoring factory settings

Page 12

Changing the Settings

1Press and hold the FILTER button for more than 3 seconds.

The unit enters the setup mode, and “W_OUT>***” appears on the display. (*** changes depending on the setting.)

The setup mode will be cancelled in the following instances

•Leave the unit idle for 8 seconds.

•Press and hold the FILTER button for more than 3 seconds again.

•Press any button other than FILTER or OUTPUT.

2Repeatedly press the FILTER button to select a setting to be changed.

For details of each setting, see page 13.

3Use the OUTPUT button (+/–) to change the setting.

4When all the settings are finished, press and hold the FILTER button for more than 3 seconds (or leave the unit idle for 8 seconds) to exit the setup mode.

<Switching off the power without closing the menu display may cause problems. Do not turn the unit off.

<Settings are stored even when power is turned off and the unit is unplugged. If left unplugged for an extended period, the settings may be lost.

Restoring factory settings

If you have made a lot of changes in the setup, and want to restart from a known set of options, restore the unit to the factory default settings as follows:

1.If the unit is on, press the POWER button to turn it off Leave the unit for 30 seconds.

2.While holding down the INPUT button, press the POWER button.

Be sure to keep the INPUT button depressed until the unit is turned on.

All memories are erased, and the unit returns to the factory settings.

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Monaural D/A Converter For Super Audio CD and CD Important Safety Instructions For U.S.AContents Before UseFeatures How to connect multiple i.LINK-capable devices Link IeeeCopyright protection system Dtcp Data transfer rateConnections SACD/CD Drive Unit P-01Signal GND connection Power cord receptacleWhen the P-01 is connected Digital audio input terminalsExample Connection to the P-01 and the G-0/G-0s AmplifierFront R G-0sDown mode Names of Each ControlOff tuned off Input select switch OffFirst Thing To Do Basic OperationPress the Output button +/- to select a channel Press the Input button to confirm the entryChanging the Settings Restoring factory settingsSetup mode will be cancelled in the following instances Press and hold the Filter button for more than 3 secondsIeee 1394 remote control function 1394RC Wout Word sync output frequencyChsel Channel Select DSD gainTroubleshooting Messages on the DisplaySpecifications Block Diagram
Top Page Image Contents