PYLE Audio PLTDF25 owner manual Using the Remote Control, Preparing and Using The Remote Control

USING THE REMOTE CONTROL

Preparing and Using The Remote Control

*Before using the remote control, please take the transparent insulator strip off the bottom of remote control.

* Point the remote control at the remote sensor (11) from no more than 6 feet away.

*If the IR sensor is exposed to direct sunlight, the remote control may not be able to communicate with it properly. You may need to relocate or shield the IR sensor.

*If you are more than 300 away from being directly in front of the IR sensor, the remote control may be unable to communicate properly.

* The remote control is small, lightweight precision device. To avoid damage, short battery life, operational erros and poor response, observe the following:

-Do not subject the remote control to excessive shock.

-Do not put in a pocket.

-Keep away from food, moisture and dirt.

-Do not place in direct sunshine.

Battery replacement

The remote control uses a lithium button type battery, model CR 2025 3V. Do not use any other kind of battery in the remote. Follow these instructions when installing or replace the battery.

1.Remove the battery holder by pressing the locking tab with your thumb

B

A

2. Replacing the battery

Replace the battery with the same type and the (+) side facing up.

3.Closing the cover

Gently push in the holder until securely locked into place.

User ’s Manual - page 8