INSTALLATION
Dashboard
Tabs
Screwdriver
Sleeve
6.Reconnect the wire harness and the antenna and be careful not to pinch any wires or cables.
7.Slide the unit into the sleeve until it locks into place.
8.To further secure the unit, use the supplied metal strap to secure the back of the unit in place. Use the supplied hardware (Hex Nut (M5mm) and Spring Washer) to attach one end of the strap to the mounting bolt on the back of the unit. If necessary, bend the metal strap to fit your vehicle's mounting area. Then use the supplied hardware (Tapping Screw (5x25mm) and Plain Washer) to attach the other end of metal strap to a solid metal part of the vehicle under the dashboard. This strap also helps ensure proper electrical grounding of the unit.
Note to install the short threading terminal of the mounting bolt to the back of the unit and the other long threading terminal to the dashboard.
Removing the unit
1.Make sure the ignition is turned off, then disconnect the cable from the vehicle battery's negative
2.Remove the metal strap attached the back of the unit (if attached).
3.Lift the top of the outer trim ring then pull it out to remove it.
4.Insert both of the supplied keys into the slots at the middle left and right sides of the unit, then pull the unit out of the dashboard.
DIN FRONT-MOUNT (Method B)
31
2
4
5
Tab
Spring Washer
Metal Strap
Mounting Bolt
Hex Nut
1. | Factory radio mounting bracket |
2. | Car radio mounting bracket |
3. | Screw |
Plain Washer
Tapping Screw
9.Reconnect the cable to the vehicle battery's negative
4. After aligning the car radio mounting |
bracket with the factory radio |
mounting bracket, tighten the screws |
(5x5mm) at 2 places on each side. |
5. When fixing factory radio mounting |
bracket with the screws, use a |
open the tabs of the car radio |
mounting bracket to make them fit |
into the holes in the factory radio |
mounting bracket . |
7