3. For display with protruding HDTV tune or deeply cur ved backs(Fig b), two 9/16” spacers(R) or two
½” spacers(S) should be used. Stack two spacers and then install them between display and the bracket. As shown in Fig 1c.
M4 Fig bit
R
I
3
N
R 3
N K
M6 Fig bit
Fig 1c
Fig b
M5 Fig bit
R | 2 | N |
| ||
| J | |
|
|
S
2 | N | L |
| ||
|
| |
M8 Fig bit |
|
|
WARNING
We are not responsible for any personal injury or product damage due to mishandling, incorrect mounting, incorrect assembly or incorrect use of this product.
Note: The supplied wall mounting hardware is not for use on steel stud walls or cold cinder block walls. If you are uncertain about the nature of your wall, please consult a qualified contractor. If the hardware you required is not included please contact your local hardware store .
Caution: This Product LCD /Plasma Wall Mount Bracket is intended for use only
with the maximum weights indicated .See apparatus instructions .Use with products heavier than the maximum weights indicated may result in instability causing possible injury .
Step 1: Attach bracket to TV
Check your TV manual to confirm the diameter of bolt to be used or choose an
appropriate bolt according to size, height and position of the holes on your TV. See pages
For correct installing, make sure that hook of every bracket must facing down. Use selected bolts, spacers and washers for installing bracket a t t h e b a c k o f d i s p l a y. A d j u s t t w o b r a c ke t s t o e q u a l h e i g h t s a n d level. Once aligned, tightly secure the bolts.
IMPORTANT: Don't force the bolt into the hole, which will cause a damage of equipments and injure of person. Don't use electric drill to fasten any bolts.
|
|
|
|