Daewoo DV6T534B, DV6T844B, DV6T534N manual Connecting with Cable Box, How to connect, Some channels

Turn on DVD-Video.

Press [OUTPUT] button of remote control and adjust DVD-Video to display ÒExternal Input 1Ó or ÒExternal

1

2

Input 2Ó in TV screen.

3 Press [PLAY] button in other video equipment.

4 Press [REC] button in DVD-Video if you want to record contents of other video equipment.

5 Press [Pause] button in DVD-Video when unnecessary or undesired scene is displayed in recording.

(Caution) Recording is released automatically after 5 minutes since pressing [PAUSE] button. Press [REC] button if you want to record again.

panel) of DVD-Video with connecting cable.

2 Connect ÒANT. INÓ jack in TV to ÒRF.OUTÓ jack in DVD-Video with RF cable.

3 To record contents of other video equipment with DVD-Video, insert recording tape attached recording tab in DVD-Video.

How to Copy(Edit) Tape with Other Video Equipment

Connecting with Cable Box

■You should install a distributor additionally.

How to connect

<Converter Box>	<Rear Panel of DVD-VIDEO>	<Rear Panel of TV>
		INPUT 1 INPUT 2
IN
OUT		ANT IN

<A/B Switch>	RF Cable
	RF Cable
	AUDIO/VIDEO Cable

<Splitter (Not supported)>	If your cable system only requires
	you to use a converter box for
RF Cable	some channels
OUT	(i.e., pay-TV channels), follow these
IN
OUT	steps: Find the primary incoming RF
RF Cable	cable. Plug this cable into a splitter
	(available at your local electronics
<Cable Antenna>	store.) Connect one RF cable
	between one OUT terminal on the

splitter and the IN terminal on the converter box.

Connect another RF cable between the other OUT terminal on the splitter and the A-IN terminal on an A/B switch (available at your local electronics store.) Connect a third RF cable between the OUT terminal on the converter box and the B-IN terminal on the A/B switch.

Connect a RF cable between the OUT terminal on the A/B switch and the ANT. IN on your DVD-VIDEO.

When the A/B switch is in the B position, use the converter box to change channels ; when the A/B switch is in the A position, use the DVD-VIDEO to change channels.

How to watch general broadcasting with recording CATV

1Set Channel Select switch of Converter Box to CH 3 or 4 as same as video exclusive channel. Press [SET] button in [VCR] operation to set video exclusive channel in ÒCHANNEL SETÓ screen.

2Press channel button of Converter Box to select channel to be recorded. In this case, if you want to watch CATV to be recorded, press [TV/INPUT] button of TV to select ÒOut (VCR)Ó.

3Press [REC] button in DVD-Video.

4To watch general broadcasting, press channel button in TV to select the desired channel.

¥For some types of TV, you should press [TV/INPUT] button in TV remote control and convert from Out 1( VCR 1) or Out 2(VCR 2) mode to Broadcasting Channel mode to change TV channel.

¥Change channel selection of CATV receiver in recording, contents of recording is changed.

Connecting with Other Video Equipment

■You can connect a wide variety of audio/video equipment to your DVD-Video, including : an additional VCR, Laser Disc Player, DVD Player, Camcorder, Satellite Receiver, Video Game. Since all of these devices use essentially the same connections, they will be described together.

How to Connect

	ANTINPUT	RF Cable
Playback VCR,
Camcorder,	A/VOUTPUT	AUDIO
Satellite
Receiver ...		AUDIO/VIDEO Cable
...		VIDEO
...

1Connect Audio/Video Out jack in other video equipment to Audio/Video In jack in rear panel (or front

Installation

12 13