Diameter Bolt Tension Knob Facing out Diagram

Step 2: Mount Monitor Brackets to a television with a curved back or an obstruction near the threaded insert

Determine the diameter of the Bolt (J,K,L) your TV requires by hand threading them into the threaded insert on the back of the TV. If you encounter any resistance stop immediately.

Once you have determined the correct diameter, see the appropriate Diagram below, thread the Bolt through the appropriate Lock Washer (M,N,O), the corresponding Washer (P,Q), the Monitor Bracket (B,C), a Spacer (R,S), and finally into the TV.

Make sure the Monitor Brackets are vertically centered and level with each other. See the appropriate Diagram below.

Tighten the Bolts (J,K,L) securing the Monitor Brackets (B,C) to the monitor.

Diameter Bolt

NOTE: If the horizontal distance between the threaded inserts on the back of the television is greater than 8-1/8 inches [206 mm] but less than 11-1/8 inches [282.5 mm], the locations of the Monitor Brackets (B & C) may be reversed from right to left. If the Monitor Brackets are reversed, the Tension Knobs must be removed and reinstalled so that they are still

R C

M5
Diameter Bolt	P
	P

Tension

Knob

facing out.

Diagram 2

Tension

Knob

Diameter Bolt