Separate the Left and Right Extension of the Wall Plate Assembly (A) and set them to so that their outer edges are equal to the desired width.
NOTE: All four of the Threaded Studs must pass through the VMXA1 for the installation to be safe.
Insert the VMXA1 so the teeth on its bottom fit into the slots in the Left and Right Extension, making sure that the Threaded Studs fit through the center row on holes in the VMXA1 as shown in Diagram 1C.
Left
Extension
Diagram 1C
Right
Extension
VMXA1
Threaded
Studs
Using the previously removed Flange Nuts and Nylon Washers, secure the Right and Left Extension to the VMXA1 as shown in Diagram 1D, and securely tighten the Flange Nuts.
Diagram 1D
Right
Extension
Left
Extension
VMXA1
Flange |
|
Nut | Nylon |
| |
| Washer |
Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 08.2.06 (100042)
Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com