Sanyo DP47460 owner manual Important Safety Instructions

Page 2

 

 

 

 

 

CAUTION

 

THIS SYMBOL INDICATES THAT DANGEROUS VOLTAGE CONSTITUTING A

 

 

 

 

 

 

RISK OF ELECTRIC SHOCK IS PRESENT WITHIN THIS UNIT.

 

RISK OF ELECTRIC SHOCK DO NOT OPEN!

 

 

 

 

 

 

 

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR

 

THIS SYMBOL INDICATES THAT THERE ARE IMPORTANT OPERATING AND

BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SER-

 

MAINTENANCE INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THIS

VICE PERSONNEL.

 

UNIT.

 

 

 

 

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

IMPORTANT SAFETY INSTRUCTIONS

1.Read these instructions.

2.Keep these instructions.

3.Heed all warnings.

4.Follow all instructions.

5.Do not use this apparatus near water.

6.Clean only with dry cloth.

7.Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

8.Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

9.Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding-type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit fully into your outlet, consult an electri- cian for replacement of the obsolete outlet.

10.Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

11.Only use attachments/accessories specified by the manufacturer.

12.Use only with the cart, stand, tripod,

bracket, or table specified by the manu- facturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

13.Unplug this apparatus during lightning storms or when unused for long periods of time.

15.If an outside antenna is connected to the television equipment, be sure the antenna system is grounded so as to provide some protection against voltage surges and built up static charges. In the U.S. Selection 810-21 of the National Electrical Code provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding elec- trodes, and requirements for the grounding electrodes.

16.An outside antenna system should not be located in the vicinity of overhead power lines or other electrical light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

EXAMPLE OF ANTENNA GROUNDING ACCORDING

TO NATIONAL ELECTRICAL CODE, ANSI/NFPA 70

“Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the build- ing, as close to the point of cable entry as practical.”

14. Refer all servicing to

qualified service personnel.

17.

Wall or Ceiling Mounting—The product should be

 

Servicing is required when the apparatus has been

 

mounted to a wall or ceiling only as recommended by

 

damaged in any way, such as power-supply cord or

 

the manufacturer.

 

plug is damaged, liquid has been spilled or objects have

18.

Apparatus shall not be exposed to dripping or splashing

 

fallen into the apparatus, the apparatus has been

 

and no objects filled with liquids, such as vases, shall be

 

exposed to rain or moisture, does not operate normally,

 

placed on the apparatus.

 

or has been dropped.

 

 

19.

When the MAINS plug is used as the disconnect device,

 

 

 

 

 

 

 

 

 

the disconnect device shall remain readily operable.

2

Need help?

www.sanyoctv.com

1-877-864-9604

Image 2
Contents DP47460 Important Safety Instructions Trademarks PC Resolution Chart FCC InformationHandling Precautions ContentsSpecifications Protecting the ScreenGetting Started Stand AssemblyPositioning the Hdtv Stand RemovalHdtv INPUT/OUTPUT Reference USB InputAudio / Video Connections Side Panel Audio / Video Connections Back Panel Initial Channel Search AV Input SelectionRemote Control Operation Channel Search Input SettingON-SCREEN Menu Operation Channel Scan MemoryXacti-LINK Video3 SettingHdmi Linking Digital Caption Energy SettingMenu Language Clock Timer Motion SyncSetup Chip Parental ControlON-SCREEN Menu Operation Picture PIX Shape Pix1ON-SCREEN Menu Operation Sound PC Input Hdtv Side PanelUSB Input Photo ViewerONE-YEAR Limited Parts and Labor Warranty Warranty ApplicationGNU General Public License Need help? Need help? No Warranty US1-T / 47-N8VG / Gxec
Related manuals
Manual 48 pages 9.52 Kb