Sanyo AVP-429 Programming your Remote Control, Quick Look at Programming a Device

Other Information

Programming your Remote Control

Your remote lets you control four devices with one easy-to-use, compact unit. After

Introductioninstalling batteries, you can program the remote to control your VCR or DVD, Cable or Satellite Receivers, Amplifier or Tuner, and Auxiliary devices. To do so, follow the instructions in Programming a Device. For best results, please read and follow all the remaining instructions. Keep this guide for future reference.

A Quick Look at Programming a Device

The universal remote control unit can t be programmed to control a TV with other brand. It has been preset to control this TV set, and this preset is unchangeable.

To control VCR or DVD, Cable or Satellite Receivers, Amplifier or Tuner, and Auxiliary devices, follow these steps. Before proceeding, find the codes for the devices you want to program in [Manufacturer's Codes] and write them down or highlight them.

		To program a DVD Player, portable DVD player, or mobile DVD player, use the
		DVD key.
	1.	Turn on the device (for example, DVD player) and, if needed, load media (for
		example, a DVD).
	2.	Press a device key (VCR/DVD, CBL/ SAT, or AUX).
	3.	Press and hold SET until the red LED blinks twice; then release.
	4.	Enter the first five-digit code for your device. The LED blinks once as each digit is
		entered. If the code is correct, the LED blinks twice.
		If the LED does not blink twice, repeat steps 2 to 4 and try entering the code again.
	5.	Aim the remote at the device and press Power. The device should turn off. If it
		does not, repeat steps 3 to 5, trying each code for your brand until you find one
		that works. If you cannot find a code that works, see Searching for Your Code.
	6.	Repeat steps 1 to 5 for the other devices you want to control. For future reference,
		write down each working device code below:
		AUX Code:
		CBL Code:
		CD Code:
		DVD Code:
		SAT Code:
		TNR Code:
		VCR Code:
	7.	Press SET to save and exit
	If your device does not respond to the remote after trying all codes listed for your
Searching for your Code
	brand, or if your brand is not listed, try searching for your code:
	1.	Press a device key once.
	2.	Press and hold SET until the red LED blinks twice; then release.
	3.	Enter 9-9-1, then the device group number (0= Cable, 1= TV, 2= VCR, 3=
		Audio). The LED blinks twice.
	4.	Aim the remote at the device and press Power. The remote sends IR codes
		from its library to the selected device, starting with the most popular code first.
		If the device responds, go to step 7.
	5.	If the device does not respond, press CH+. The remote will try the next code.
		Continue until the device responds.
		Press CH- to try the previous code.
	6.	To search for other device codes, repeat steps 1 to 5.
	7.	Press SET to save and exit.

42